1.25" OD, 0.25" ID single race radial bearing using Airsoft pellets
1.25" OD, 0.25" ID single race radial bearing using Airsoft pellets
3D
Published 2017-06-01T14:03:36+00:00
First attempt at a bearing. I don not personally recommend its use due to friction between pellets causing them to not roll properly.
3D printed bearing designed for high load and low speed applications. Light post processing required.
Requires 9 airsoft pellets. High Density preferred.
Parts are in inches. Print with higher infill to produce a sturdier bearing. Recommended finest resolution and slowest print speed.
1. Print parts.
2. Nest center shell within the outer shell while holding the two in place. If you intend to lubricate the bearing, use silicon grease.
3. Push Airsoft pellets into the bearing through the hole in the side of the outer shell. Rotate inner shell to disperse pellets from hole.
4. Seal hole with the provided plug.
Parts are in inches. Print with higher infill to produce a sturdier bearing. Recommended finest resolution and slowest print speed.
| 发表的日期 | 01/06/2017 |
| 让时间去下载 | - 120 分钟 |
| 材料数量 | 5 |
| 尺寸大小 | 302mm x 302mm x 12mm |
| 打印工艺 | FDM |
| 复杂程度 | 非常容易 |
| 支持自定义 | YES |