1:48 MSN-01 Psycommu Test High Mobility Type Zaku II ver.Thunderbolt
1:48 MSN-01 Psycommu Test High Mobility Type Zaku II ver.Thunderbolt
Published 2018-10-02T08:42:20+00:00
you need....
-14x10(outterxinner) Silicone tube
-10x8 Silicone tube
-8x6 Silicone tube
for joint, and
-10 x 70mm cylinder
for Hip joint
-8 x 50mm cylinder 2ea
-m3 bolt 4ea and Proper wooden panel
or 10 x 200mm cylinder 2ea
for base
i draw finger as movable, but it's almost impossible. just glue it. and manual is not ready. watch this.
https://a360.co/2Re5XJt
well, it's my first full 3d printable model so some(in fact, almost every...) part make you crazy because not fit. don't be stress. just cut and glue it.
have a good time!
ps1.
The files in the cube folder are organized in a 150x150 compartment in stl format. If you do not mind, you will not have any trouble making it out if you print only the parts in the cube folder.
separate part you can find here
https://drive.google.com/open?id=1F3DL2odBx7nrlnQFvFm9yrxYDnsvqlfz
ps2. in base cube, there are two A strange parts. it's connector for bandai action base
ps3. don't print it as PLA. it make you crazy when you sanding the parts...
发表的日期 | 02/10/2018 |
打印工艺 | FDM |
复杂程度 | 容易 |