2x2 Filament Shelf Bracket
2x2 Filament Shelf Bracket
Published 2018-08-21T14:23:21+00:00
2020 Update: Added a version with a through hole on the lower mounting point for easier access to the screw while hanging. Either way, I use a regular screw driver to put the screws in the wall after punching the holes with a power drill.
I took a bit (a lot) of inspiration from Joel Telling's spool mounting bracket, but I had a 2x2 lying around instead of a 1x2. Also, I used this project as an opportunity to mess around with the simulation tools in Fusion 360. Results pictured with 98N (10kg) of load assuming solid PETG. Not bad! I actually printed it in PLA, but the two brackets share the load so it should be well within the safety zone.
Be sure to use a heavy duty mounting screw on the upper screw hole (like a toggle bolt) if you're mounting to drywall. Overall, everything looks good and shows no sign of failure under load.
Printed at 0.3mm layer height and 20% cubic infill in PLA on a Prusa MK2.5
发表的日期 | 21/08/2018 |
让时间去下载 | 150 - 分钟 |
材料数量 | 50g |
尺寸大小 | 214 x 115 x 15mm |
打印工艺 | FDM |
复杂程度 | 容易 |
支持自定义 | YES |
PLA, PETG, SBS and natural wood