3DTAC / Sight Riser
3DTAC / Sight Riser
Published 2018-08-20T16:14:14+00:00
Features -----------------------------------------------
- Simple lock & key design, prints really easy and requires no supports.
- Long and short rail included.
- Raise your scope (20mm) and get a better sight picture.
- Print files as pre possitioned for best results.
- You will need two 3/16x1 1/4 (4.8x36mm) screws with nuts.
Info-----------------------------------------------------------
3DTAC products are professionally designed using engineering software and 10 years of working experience. Our designs are: consistent, strong and precise to guarantee great results each print.
Tip me here: paypal.me/3DNG
Want to print and sell these? For a small licensing fee you can do that while helping us design and make more cool stuff: https://www.patreon.com/3DNG
DO NOT USE WITH REAL STEEL FIREARMS. This is an accessory designed entirely for Airsoft and sport air shooting. I take no responsibility for any harm taken or done should this design be miss-used on other activities outside its designed purposes.
ABS / PLA
Scale part up .3% = 100.3 (ABS only)
Temperature: ABS 230°C / PLA 210°C
Layer .1 to .3 mm
Perimeters: 3
Infill: 50% (at least)
Supports: NO
Cooling Fan: ABS OFF, PLA ON
Raft: No (unless needed by your particular printer)
发表的日期 | 20/08/2018 |
让时间去下载 | 70 - 90 分钟 |
材料数量 | 35 |
尺寸大小 | 34x150x27 |
打印工艺 | FDM |
复杂程度 | 容易 |
支持自定义 | YES |