Anycubic Photon Rear Vent 4inch Addon
Anycubic Photon Rear Vent 4inch Addon
3D
Published 2018-05-16T16:43:21+00:00
@DocTanner created a nice Rear Vent duct adapter for the Anycubic Photon. You can find it here: https://www.myminifactory.com/object/3d-print-64661 .
I just wanted to have an Addon for it to add some filters (Hepa, Active Carbon) in the first part of it and a 12V PC Fan 120mm. So i created a nice little Addon to hold the filters and the Fan. This Addon is for a 120mm fan.
Between the two grills is space for the filters and will hold there.
To hold the Addon on place and seal it, i used Hot Glue, so i have a tight seal and can access the filters anytime. You could make a holes to both to screw it, but i don't recommend it.
There is nothing special to print it Just lay the grills on the build plate and go
| 发表的日期 | 16/05/2018 |
| 让时间去下载 | 300 - 320 分钟 |
| 材料数量 | 51 |
| 尺寸大小 | 121x121x121x |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |