Aviator Sunglasses
Aviator Sunglasses
3D
Published 2018-01-02T18:14:29+00:00
This is a replacement frame for Rayban Aviator lenses (in case your original frame has been damaged). Filament (1.75mm) is used as pin for the hinge. You can use hot water or a heat gun (with caution) if you cannot insert the lenses. The same way you can modify the curve of the temples if you are not satisfied with the fitting.
For the best printing result it is advised to use PVA for support material. Otherwise, it is important to use the suggested settings below.
Cura Settings (for the frame)
Layer Hight : 0.1mm ( or 0.06mm)
Support : Yes
Support Density : 20%
Support Z Distance : 0.2mm
Support Horizontal Expansion : 0.5mm
Enable Support Interface : Yes
Support Interface Thickness : 0.4mm
Support Interface Density : 100%
Brim : 1mm (for the frame, if you have adhesion problems)
| 发表的日期 | 02/01/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 困难 |
Tough to print without soluble filament... lot of post print processing to get them to look good. Totally worth it though! I love them! Printed in NGen