Conservation of Angular Momentum Fidget Spinner
Conservation of Angular Momentum Fidget Spinner
3D
Published 2017-08-15T15:03:17+00:00
June 2017 Update: I uploaded an new version which works without a ceramic bearing.
This spinner speeds up as it slows down. When spun initially the magnets move to the outer position. Then as it begins to slow, the magnets shift to the inside position, which causes it to spin faster.
Inspired by example prints from whosawhatsis's book, 3D Printed Science Projects*.
Use the following:
1 - ceramic 608 bearing*: the bearing needs to be non-magnetic otherwise the magnets will stick to the bearing and add a lot of drag.
4 - 10mm cylinder magnets*: careful, these magnets are very strong and somewhat brittle. They should be set to attract each other. There should be inserted from the bearing cavity, and there's a small ledge near the bearing that holds them captive so they don't hit the bearing when they move in. The ledge makes it a bit harder to insert the magnets, but they should move freely once they're pushed past the ledge.
Atomic Filament Amethyst Violet Gemstone Translucent PLA.
*affiliate links
| 发表的日期 | 15/08/2017 |
| 打印工艺 | FDM |
