Daedric Shield from Skyrim
Daedric Shield from Skyrim
Published 2017-05-04T09:58:53+00:00
Daedric Shield from Skyrim. I would start with file 1 and go to 9. The first three files are the right outside of the shield, 4-6 are the middle and 7-9 are the left outside.
With 10% infill all the pieces should take about 340,673 mm of filament to make and about 46 hours to print at normal speeds. I have been slowing down all my prints from this time by 10-17% because I like print quality over speed. I'm not in any hurry to get anything done.
I included the original file so you can take a peak and see the size and if it is what you are interested in.
I have just started to print this and should have an update by the middle of march on how it turned out.
* UPDATE **
I have almost completed printing this. I found that the handle is a bit small and come to the conclusion that Daedra have tiny hands. It you are just printing this as a wall display than this is not an issue. I will think about enlarging this and cutting up the pieces.
Enjoy and good luck with this one
发表的日期 | 04/05/2017 |
打印工艺 | FDM |
复杂程度 | 中级 |