Double Walled Travel Mug
Double Walled Travel Mug
3D
Published 2018-02-06T12:42:44+00:00
This is my entry for the Esso Upcycling Challenge and what goes better with Esso than a traveling mug!
This mug has two walls to insualte the drinker from hot or cold and uses the natural 250mL top to prevent spills while traveling.
It only takes a few supplies and about 15 minutes to assemble.
1) Gather the printed cup_base and cup_top along with 2-3 250mL cans, a pair a scissors, and some tape.
2) Insert an intact can into the cup_base, slide the cup top over the can, then screw the cup_top and cup_base together.
3) Remove the tops and bottoms of the remaining cans and cut a vertical cut down the seam of the can. Cut the top and bottom portions off where the can bends inwards to make a flat rectangle.
4) Work the rectangle into the outer groove of the cup_base with the seam of the can aligned with the handle. Carefully slide the can into the outer groove of the cup_top until the sharp edges of the can are covered on both ends by plastic
5) Tape the vertical seam to cover sharp edges. Wrap tape around the upper and lower seams, overlapping the plastic and the can to secure the can in place.
Printer - FolgerTech Prusa i3 clone
Material - PLA
Layer Height - 0.3mm
Nozle Width - 0.4 mm
Support Material - No
| 发表的日期 | 06/02/2018 |
| 让时间去下载 | 6 - 20 分钟 |
| 材料数量 | 200g |
| 尺寸大小 | 65 mm x 65 mm x 170 mm |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |
