#TinkercadEaster Chocolate Heart
#TinkercadEaster Chocolate Heart
3D
Published 2018-03-12T13:36:26+00:00
This egg has got a heart's mold inside, it can be filled with melted chocolate to make a solid chocolate's heart.
Here below some instructions to follow:
- put some crumbled chocolate in a ceramic cup
- heat up the cup in a microwave over using low power (280-350 W) for 10-15 seconds
- when finished, stir the chocolate with a metal or plastic spoon
- repeat 2nd and 3rd steps until all chocolate is melted
- accurately cover the mold with aluminium foil; it must take heart's shape to facilitate the final extraction of the solid chocolate
- pour the melted chocolate until the mold is full
- cover the mold's surface with a flat disk of aluminum foil
- put the other half of the plastic egg on the aluminium disk
- apply some rubber bands on the egg to keep the two halves firmly togheter
- put the egg into the freezer for about 30/40 min
- disassemble the two halves and exract the chocolate's heart
- enjoy!
This object was made in Tinkercad. https://www.tinkercad.com/things/8Hfk7t0e45V
Infill: 10%
Layer Height: 0.3 mm
No raft
No supports
| 发表的日期 | 12/03/2018 |
| 让时间去下载 | 60 - 100 分钟 |
| 材料数量 | 15-20 g |
| 尺寸大小 | 93,5x46x30 cm |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |
