ESSO-doc tubes
ESSO-doc tubes
3D
Published 2018-02-14T16:39:47+00:00
Hi everyone, so here is my take on a versitile carry case that can be customised to which ever size you need, just make sure you have a good quality rope/Drawstring (line). To assemble you need to cut the bottoms and tops of your 25Ml cans and safely insert them into the Docs tubes using as many as you need to cater to the size of paper, drawings, paint brushes etc. (Be carefull of sharp edges when assembling) Usung the holes thread the rope through to turn it into a draw string shoulder carry case.
This Was among many of my started but not finished first idear entrys to the Esso comp for upcycling the 250Ml can. i was origonaly gonna make it a three tube but by the time id gotten this far, as far as i was concerned, it had already been done.
I have printed and used this carrier so it is functonal. While theres more i'd like to do to it it works.
If you do print your self a set, cutting your cans as straight as possible will realy make a big diffrence to how straight your tube ends up. :)
Again, Happy printing :)
Designed on Flashprint
| 发表的日期 | 14/02/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
