Fargo 3D Printing Ornament
Fargo 3D Printing Ornament
3D
Published 2017-08-16T15:32:42+00:00
Made in-house to be sent off with our Christmas card.
Our logo is extruded on the front and a stylized snowflake is inset on the back. The center is held in place with fitted cones and prints in place.
Prints in about 25 minutes and a two color switch point would be about 70% (on MakerBot Rep 2 with raft and default settings).
Please share your make if you decide to print one!
Here are some videos of Jake and Eric messing with an earlier version of the model (this one doesn't spin nearly as much).
https://www.instagram.com/p/_APJSPiDwJ/
https://www.instagram.com/p/_APnz8iDw8/
The fit isn't perfect, but we don't want the center falling out too easily. Round fittings instead of pointy cones might be the answer.
Printer brand : MakerBot
Printer : MakerBot Replicator 2
Rafts : Doesn't Matter
Supports : No
| 发表的日期 | 16/08/2017 |
| 支持自定义 | YES |
