Ghosts in the Window (or Wall)
Ghosts in the Window (or Wall)
3D
Published 2017-03-21T16:14:38+00:00
'Ghosts in the Window (or Wall)' is a decorative print for Halloween or fun anytime. This is a two part print that is intended to create the illusion of a Ghost travelling through a solid window or wall... because half is mounted one side and the other half mounted on the other side. Simple but effective!
Three .stl files have been provided. One is for both parts in a single print the other two are each part ready to print individually. At standard scale the Ghosts are approx. 85mm tall. Print in white, translucent natural or glow-in-the-dark filament.
Provided your prints stick well to the build plate this should be an easy print. Ghosts don't use a lot of filament (Just over 30gm at standard scale with a Raft) but as they have thin walls, so a lot of outlines, do take a while to print.
Apply some good double-sided tape or similar to the flat surfaces of your Ghosts then stick in place so it appears as a single entity travelling through the solid object. Making sure the two halves are aligned will ensure the effect looks great.
Please refer to the instructions and images for additional information... and post images of your ghosts and where they are haunting.
Note: If you like this check out the rest of my fun and practical designs.
Provided your prints stick well to the build plate this should be an easy print. Ghosts don't use a lot of filament (Just over 30gm at standard scale with a Raft) but as they have thin walls, so a lot of outlines, do take a while to print.
Mount your Ghosts in a window or wall...
Apply some good double-sided tape or similar to the flat surfaces of your Ghosts then stick in place so it appears as a single entity travelling through the solid object. Making sure the two halves are aligned will ensure the effect looks great.
| 发表的日期 | 21/03/2017 |
| 打印工艺 | FDM |