IOS/Android Tablet & Phone Simple Wall Mount (Ipad/Samsung etc)
IOS/Android Tablet & Phone Simple Wall Mount (Ipad/Samsung etc)
3D
Published 2019-04-29T16:22:20+00:00
A model I made for various tablets and phone devices to the wall for charging or use for easy touch screen access.
I personally use a pair for an Ipad Pro and a Samsung S3 tablet. The slide is about 9.5mm across so you can figure if you have a device with a cover, as long as it's thickness is less than that, it should still be able to fit. Since without any coveres the devices still have some room.
I usually feed the charging cord through one of the slots when not in use.
Print model on the side with opening facing up, no supports needed.
Printer: CR-10 Mini
Supports: No
Resolution: 0.2-0.3
Infill: 25%+
Filament: Dikale PLA Black
Notes:
Print a pair and adjust on the wall accordingly. Hole for screw is just under 4mm diameter depending on your print layer accuracy.
Opening/slot where tablets and devices slide into is approx: 9.5mm.Total overall model length is just about 75mm.
| 发表的日期 | 29/04/2019 |
| 支持自定义 | YES |
