Lunafreya's Trident - Final Fantasy XV
Lunafreya's Trident - Final Fantasy XV
3D
Published 2017-05-25T17:45:19+00:00
Lunafreya Trident from Final Fantasy XV
This was modelled to fit onto a 42mm/1.66 inch pipe, though the example in the image is using a 40mm pipe, built up with tape to the required thickness. With the pipe/shaft at 3ft 4 inches/40 inches, the trident is around 6ft 8 inches/80 inches long.
The tail section is designed to include 3mm thick rods for extra strength and alignment. 1 rod at 327mm long, and 2 at 149mm long.
If you would prefer to scale it down for a smaller diameter pipe, I would recommend testing the scaling with "High Sleeve 2" which is the shortest print of the shaft mounted parts.
Some notes:
- All 11 head parts must be printed twice for the mirrored side.
- Both "Tail Spike" files needs to be printed twice.
- "Side spike" contains both halves of 1 spike. Needs to be printed 3 times total.
I printed at 0.2mm, 10% infill, for a total print time of 109 hours, and 480 metres of filament
Credit as @MarkStanton89 on Instagram/Twitter
| 发表的日期 | 25/05/2017 |
| 让时间去下载 | - 6540 分钟 |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |