Mad Hatter Tea
4,031
views
174
downloads
0 comments
Loading comments... 
Mad Hatter Tea
3D
Published 2018-02-07T11:57:39+00:00
18
0
Add to Collection
Description
Its always tea time with this 250ml challange. Steap your tea with Mad Hatters hat.
After printing your Mad Hatters Hat take your can and remove the lid with pliers and do your best to remove any burs on the side.
Poke holes on the bottom of the can with a needle. The more you poke the better but do your best to keep the holes as small as possible. To better increase drainage poke a a few slightly larger holes on the very bottom of the can.
Now insert your can into the Mad Hat with the bottom of the can poking at the bottom of the hat (this is were the loose leafe tea will steep).
Enjoy!
Technical Information
| 发表的日期 | 07/02/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
More Information
Object Parts
