Nautilus Gears Stand
- 游戏和玩具 |
- 教育>
- 物理 |
- 游戏和玩具>
- 玩具>
- Learning Toys |
- 教育>
- Design & Technology |
- 教育>
- Middle Schools |
- 教育>
- High Schools
Nautilus Gears Stand
3D
Published 2018-07-20T16:16:42+00:00
This object was made in Tinkercad. https://www.tinkercad.com/things/7q8ei3KPecB
This supports the original non-curved connect bar located at: https://www.myminifactory.com/object/3d-print-nautilus-gears-8691
Here is a video, using the stand to hold the gears in the air, making it easier to demonstrate their spinning: https://youtu.be/Pf5QCR7yPSQ
It attaches very well, and makes it much easier to carry and spin the nautilus gear, especially when demonstrating to others. I am able to spin the gears very quickly and many times, it is like a challenge to see how long I can keep it spinning. I can place the stand on a table or ground and it still holds and spins the gears very well, or I can carry it (using the center hole to insert a finger to grasp better if I need to).
I also found if you rotate the stand where the center hole is facing the ground, so that the gears are vertical -- the gears can spin themselves!
I printed using QIDI X-PRO black ABS, shown in the photos. The male peg in the connector bar is easy to break, so be careful. The black ABS I used seem to require very hot, like 240degC but I used only 80degC for the heating plate. I printed with supports and 20%, but I think it may be possible to print this without supports.
| 发表的日期 | 20/07/2018 |
| 让时间去下载 | 60 - 180 分钟 |
| 尺寸大小 | 62mm long x 18mm wide x 39mm tall |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |