Paint Pole Camera Mount
Paint Pole Camera Mount
3D
Published 2018-09-10T09:12:14+00:00
This part allows you to mount a camera to a paint pole, I used an extendable paint pole so I could get my GoPro camera above crowds when filming.
Part is designed to hold a 1" long 1/4-20 screw/bolt, with a 1/4-20 hex nut on top to retain the screw and prevent it from spinning or falling out.
Included step file can be used to modify the mount to use a shorter screw, just reduce the height of the mount buy the amount needed for the shorter screw.
This is a remix of the paint pole to 1/4-20 (tripod-size) hole part on Thingiverse, created by fixingyourvideo
Printed on my Anet A8 printer.
Supports required over the build plate. Don't use Supports everywhere or you may get supports inside of the internal threads, which would probably be very difficult to remove if not using some kind of soluble support material.
.2mm layer height
20% infill (chose a stronger infill pattern for strength)
| 发表的日期 | 10/09/2018 |
| 让时间去下载 | 90 - 分钟 |