Paper Roll Dispenser (holder)
Paper Roll Dispenser (holder)
3D
Published 2018-05-17T14:20:52+00:00
This my second project for kitchen stuff designing in Blender software & I think it worked pretty well!
The Need:
Wanted to make some comfortable paper roll holder for my Red/Grey kitchen - so I made one!
The Design:
In the design process I didn't thought about the thickness of dispenser , so had to redesign it after first print ^^ But it's good that i tested it - so now i can assure you, it's holds it like it should!
The Print:
Printed with ABS, both parts (Holder X 2, Tubes X 2) and made an acetone wiping smoothing something like an hour or so... The model will be set in kitchen so I didn't want to take chances with the ABS+Acetone finishing, so at the end - covered it with some glossy lacquer too.
The Assembly:
Use 2 screws to put on wooden surface after you measured the distance for paper roll width. You can use two sided tape (good quality one) to glue it to the surface to i think...
Printer:
Anet A8
| 发表的日期 | 17/05/2018 |
| 复杂程度 | 容易 |
This is awesome! Thank you!