Ravenclaw Coat of Arms Wall/Desk Display - Harry Potter
45,800
views
11,941
downloads
151
collections
11 comments
Loading comments... 
Ravenclaw Coat of Arms Wall/Desk Display - Harry Potter
3D
Published 2015-07-30T15:18:52+00:00
1883
11
Add to Collection
Description
This is the Coat of Arms version of the Harry potter Houses logos. I have included a fun little hogwarts desk stand with the file so you can display it on your shelf or desk. There is also a key hole slot near the top of the model for you to hang your decoration proudly on the wall!
This was part of a project with loads of other models so take a look at my profile to find the rest of the models and choose your house!
Printing Details
All prints where done using grey PLA on a Flashforge Dual, using 0.15 mm layer thickness and 15% infill.
Technical Information
| 发表的日期 | 30/07/2015 |
| 让时间去下载 | 350 - 360 分钟 |
| 尺寸大小 | 10.27 x 12.213 x 1.934 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
More Information
Object Parts
I initially printed this in black, flat on the build table, .1mm layers to try for as much detail as I could get. Then it occurred to me that if I tilted it up to about 45 degrees, the printer would generate much of the face detail with horizontal motion instead of layer deposition. True, it would require a LOT of support, but most of that was on the back face and easily removed. So I experimented, and found that 39 degrees did a pretty good job of keeping extra support from being added around the edges. I printed the tilted version in purple. Here are some comparison photos of the black (flat, .1mm layer height) and purple (tilted, .2mm layer height).