3D Print In Place Robot Reindeer for “Tinkercad Christmas”!
3D Print In Place Robot Reindeer for “Tinkercad Christmas”!
3D
Published 2017-12-04T12:06:29+00:00
This is a Print in Place robot reindeer! All of the joints move and it is fully printable without extra support or rafts. The head also folds back into the body, so it easy to carry around without breaking, and also makes for a cool aesthetic. It was designed in tinkercad, for the “Tinkercad Christmas” design competition. Depending on how good a tolerance your printer has, the joints might weld together, however most printers/nozzles should handle it just fine.
This object was made in Tinkercad, you can find it here: tinkercad.com/things/8hAPxRqYtel
Thanks for printing and I hope you enjoy :)
Does not require supports or rafts, if you do use them however, make sure they aren't in the joints.
Build plates with a print volume lower than 120x120x120, may struggle to print the joints, especially with low tolerance or worn out nozzles. Can be printed in two parts. Also when printing make sure the head is seperate to the body.
Note: resizing the model (especially downsizing) will affect movement in the design. If you wish to have a small version of the model, make the holes between joints bigger, or ask.
If you wish to get the paint effect in the pictures above:
1. Carefully tape up both the antlers and the nose
2. Make sure the model is in a standing position and lightly spray desired colour, from a distance, over the top of the model
3. Remove tape and paint the nose gloss red with a brush
| 发表的日期 | 04/12/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 非常容易 |
| 支持自定义 | YES |
Super easy print