Shredded Skull
Shredded Skull
3D
Published 2014-10-11T02:33:32+00:00
2014 Halloween Design Competition entry- Curiosity Cabinet
I call these "Shredded Skulls". I used an open sourced skull model and used some intersect modeling to create this awesome look! There is a spot on the eye that needs supports but I've printed it several times without and had great results. Print single perimeter, 2 tops, 1 bottom. 5% infill should be enough. The goal is to have enough infill to support the top of the skull. I've printed it without infill but the smooth top portion of the skull can get messed up. Also make sure your retractions are good. I had to adjust slicer and reduce the minimum retraction distance from 2 to .5. Enjoy!! If you print it and post a picture somewhere be sure to tag me so I can see it! @ImmersedN3D
Print at 0.2 mm layer height, with 25% infill. This takes 960 minutes and uses 156g of filament.
| 发表的日期 | 11/10/2014 |
| 让时间去下载 | 960 - 960 分钟 |
| 材料数量 | 156 g |
| 尺寸大小 | 104 x 90 x 103 mm |
| 复杂程度 | 中级 |