Snow saw handle to replace the piece of heat shrink tubing that served as the original handle on the Life-Link® snow saw. It should be printed in Ninjaflex or a similar elastic filament (the printed handle needs to stretch when installed).
The handle is front-back symmetric so the same part can be used for either the left hand or right hand by rotating it. It is not top-bottom symmetric, the slightly wider slot should be used as the top of the handle (it is printed upside down).
This was designed to fit the Life-Link® snow saw, but there seems to be more than one version and I'm not sure if it will fit the others.
LIFE-LINK® is registered trademark of a company which does not sponsor, authorize or endorse this design.