Tablet Stand - Modern style iPad / Tablet stand for use on a desk
Tablet Stand - Modern style iPad / Tablet stand for use on a desk
3D
Published 2017-03-20T19:24:20+00:00
There are lots of tablet stands available so this is just another option. It will support most tablets including iPads with or without a cover. The design looks modern and high tech as well as being lightweight so it doesn't use a lot of filament or take up a lot of space.
The tablet is simply placed into the centre of the stand. It angles up at the back approx. 26 degrees which seems to be about the angle most users find comfortable for use on a desk.
Prints well on a Replicator 2 with Raft, 4 shells and 20% infill at 0.20mm (Std) resolution. No supports are required. However, as some angles are near the limit for PLA to print out unsupported, the lower / underside edges of some areas may be a bit rough. If this happens it should be relatively easy to clean up with a craft knife... this is much easier than having to clean away support.
| 发表的日期 | 20/03/2017 |
| 打印工艺 | FDM |
