Ultimaker 2 and 2+ front window clip
3,219
views
62
downloads
0 comments
Loading comments... 
Ultimaker 2 and 2+ front window clip
3D
Published 2018-05-29T13:32:12+00:00
1
0
Add to Collection
Description
If you use ABS you must cut air movements from outside. For the Abs to stick to the surface, keep the pure acetone and a piece of natural abs filament in a container for one day and apply the film as a thin layer to the surface while it is cold and wait for its drying.
My front window has 28cm width, 34cm height and 3mm thickness. Clips designed for this dimension and there is no tolerance. If you cannot fix the window you can use sandpaper.
(My advice is 50% filling)
Good luck,
Technical Information
| 发表的日期 | 29/05/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
More Information
Object Parts