valve for a sawdust extraction system
valve for a sawdust extraction system
3D
Published 2018-10-31T14:41:17+00:00
I created a valve in two sizes for the (saw)dust extraction system in our workshop. It makes it possible to activate the suction for specific appliances without having to change the position vacuum cleaner.
The lid is secured from falling out using two short M3 screws and nuts.
It fits standard PVC drain pipes with an inner diameter of 40 or 50 mm (both sizes are available).
You can modify the fusion 360 source models as you like:
The more horizontal parts of the pipe were printed using a resolution of 0.1 mm, while everything else was printed using 0.3 mm resolution for a faster print.
Use two or more wall perimeters and better choose more than less full top/bottom layers ;).
Infill: 30%
| 发表的日期 | 31/10/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |