Voronoi Bracelet 2
Voronoi Bracelet 2
3D
Published 2017-10-05T14:42:54+00:00
The outer radius is about 2.95 in (75 mm). The average bangle bracelet size is between 2.3-2.5 in. I left room for you to make some minor sizing adjustments.
This was a relatively quick design. I made a twisted torus first. I scaled the torus up and applied a mosaic pattern. I then inset by polygon and deleted the faces leaving a frame. I shelled it and applied a turbo-smooth to create the voronoi appearance. It took me about 30 minutes of trial and error before settling on this design. Rendering the three pictures took about an hour.
Voronoi is tricky to print without an SLS printer, it is possible though, but needs a lot of internal supports which are difficult to remove afterwards, I broke the bracelet to remove mine. A UM3 with water soluble supports might print this better. The 3D model itself is nice though!
| 发表的日期 | 05/10/2017 |
| 让时间去下载 | 60 - 120 分钟 |
| 材料数量 | 5 |
| 尺寸大小 | 20x20x10mm |
| 打印工艺 | DLP/SLA |
| 复杂程度 | 容易 |