Sneaky Bubble Pipe #Tinkerfun #Tinkercad
Sneaky Bubble Pipe #Tinkerfun #Tinkercad
3D
Published 2018-06-18T10:12:21+00:00
This object was made in #tinkercad. https://www.tinkercad.com/things/7cl0KUaaJhK
Inspired by the "assassin's tea pot" where you cover one hole to dispense tea and the other to dispense milk. My goal was to make a two chamber bubble pipe, one to hold a reservoir of bubble solution and the other, water, for a tiny spray.
The water spray doesn't work very well and needs a redesign but I hope it inspires others to create their own stealth summer fun. This was a fun attempt to make something complicated with only primitive geometries and my first attempt with Tinkercad. #Tinkerfun
Check out this wonderful video on the teapot on Grand Illusion's
I would only recommend, should someone try to make or modify, the neck needs to be thicker as it was a bit thin and hard to adjust the thickness properly. Even still it's a bit on the thin side.
This file was designed to print in place and needs no support.
Use 100 - 102% flow rate and a bit higher temp to improve fusing of material for a more water-tight print. For some printers this might require a z-hop to get over the lifting around the holes and capping surfaces.
In the images you can see some pattern flaws. This is because I made the printing speed high/fast to get a woody look from the ringing of the printer working too hard to speed up and slow down.
| Date published | 18/06/2018 |
| Benoetigte Zeit | 1 - 2 Minuten |
| Menge an Filament | ~25g |
| Dimensionen | 43.3 x 40 x 112.8 |
| Support Free | YES |