Climbing Trainer Hangboard
Climbing Trainer Hangboard
Published 2018-12-10T14:12:11+00:00
This is a design I made a while ago, but only upload it just now, because I wanted to verify first its usability. Now that I found a proper space to mount it at my place, I can share it with you without hesitation. It gives you multiple ways to use:
- First you got the big grips on the top, they are very nice to just do pull-ups, like you wound normally do on a bar
- Then there are the finger holes, you got space to practice finger strength with 4, 3, 2, or one :b finger on the top holes, they are a bit deeper
- There is also the second level of grips, this one is not that deep and for advanced training
- Last there are some slope grips on the top, if you are into that stuff
I mounted mine on a wooden board, which I screwed to the wall, you want to use one of at least 2.5 cm/1 inch (my meassurements are 80cmx10cmx2.5cm), else you can’t grip around the top!!! To screw it to the wood first push a M5 Nut into the hole, I made an inset, so it should fit right in. This helps to reduce the force of the screw on the plastic.
If you have questions, don’t hesitate to ask!
Use thick walls and infill of about 50% or more, to make it nice and stable. You got to use some Support under the top grip, shouldn't be a trouble if the surface gets a bit rough from that... gives you more grip, and it’s on the back side anyway.
Date published | 10/12/2018 |
Late reply but I wanted to get my printer ready for these bad boys. Thanks for the info and I hope more people print this awesome hangboard if you ever make another training part I’ll gladly test it. Hope to keep seeing stuff from you. Great work!!!