Drogo Smart Phone Stand
Drogo Smart Phone Stand
Published 2017-09-06T16:42:40+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
Trying to model a dragon from game of thrones. Ended up with a low(ish) poly tiny dragon. Should be able to hold most smart phone models.
This model was created with VECTARY - the free, online 3D modeling tool
Credits:
This model was printed at 60% scale with 10%infill and 0.3mm layer height. Support is needed. The design intent is to hold the smart phone in between the wings with the foot piece on the tail. The resulting model is quite big but looks good too me :)
This model was printed at 60% scale with 10%infill and 0.3mm layer height. Support is needed. The design intent is to hold the smart phone in between the wings with the foot piece on the tail. The resulting model is quite big but looks good too me :)
Date published | 06/09/2017 |
Menge an Filament | 87g Including supports |
Dimensionen | 210 x 211 x 187 at full scale |
Technologie | FDM |
Schwierigkeitsgrad | Medium |