gjallarhorn 2.0 - Destiny
gjallarhorn 2.0 - Destiny
Published 2016-02-29T11:55:56+00:00
This is a redesign of the original Gjallarhorn uploaded here. With this redesign it prints faster and is much sturdier.
Some elements were taken from the original gjallarhorn to help me make it faster. This uses a 75mm / 2 ½ inches PVC pipe and a 90mm / 3 inches PVC pipe. There is a Printable reduction connector in the zip folder.
This model was hand painted by the talented Sarah Wade.
Below is a video on how the gjallarhorn was assembled.
(PLEASE: Do not sell or upload on any other websites without my permission.
I will really appreciate if you tag me and credit me.
Thank you in advance for your support)
Print all the parts as they import. the total print time for me was 3 days / 70 hours cut the 90mm pipe 440mm long cut the 75mm pipe 750mm long
Date published | 29/02/2016 |
Benoetigte Zeit | 4200 - 4500 Minuten |
Technologie | FDM |
My 3d printed gjallarhorn. Was done on a TAZ 5 with hatchbox PLA. Took about 2 rolls of PLA at 12 percent infill. Took me about 2 and 1/2 weeks to print everything and quite a bit longer to sand and paint. As i stated in the comments section of this post if you live in the USA and want to make this then you need 3 inch and 3.5 inch PVC pipe. You then must print every part at 98% scale for the pipes to fit into the pipe connector and barrel sections. All of the parts fit together really well.