guitar wall holder
guitar wall holder
3D
Published 2015-06-16T19:00:37+00:00
This is a piece i designed to hang my guitars on
they are all on my wall because i see them as decorotive and as instruments
its printed with 50 % infill so it can hold my solid wood electric guitar
the desing may look silly in 3d but when you printed it it looks nice and hangs a guitar verry wel ( neck with max 50 mm )
how to mount it ?
Well there is 3 screw holes
-1 in the top
-2 in the bottom
you can use screws 4 mm to drill it onto the wall
if you would like a different desing ask me i wil draw it
3d printer requierements
layer height between 0.20 mm and 0.28mm
minimal of 50 % infill
abs or pla
no infill is needed
piece needs to go on its back with the 2 struts pointing to the sky
watch out with pulling it of the bed , the guitar strings are verry delicate
best of luck with it
chef
Print at 0.2 mm layer height, with 10% infill. This uses 40 g of filament and takes 3 hours 37 minutes.
| Date published | 16/06/2015 |
| Menge an Filament | 40g |
| Dimensionen | 90x190x90 mm |
| Schwierigkeitsgrad | Easy |
