Monopoly Top Hat Game Piece Holder /Lid
Monopoly Top Hat Game Piece Holder /Lid
3D
Published 2018-05-14T10:15:48+00:00
Monopoly Top Hat Game Piece Holder /Lid
This is a Top Hat Shaped holder for the game pieces in Monopoly. It was designed for use with the figures, houses, and hotels in the standard version of Monopoly and should fit other editions so long as the number and size of pieces are the same. If not, scale it up. But it's height, including the lid, was designed to fit inside the box of a standard edition game when in storage (although the lid is not required to keep objects inside during storage, a shake of the box confirmed this). So, upscaling will likely require storage outside of the box. It is designed to hold only one set of pieces, so unless scaling up you will need three of them.
**The lid will not close when storing houses or hotels, so only print one, for the figures/dice, if you want to**
Disclaimer
Although I usually print at a layer height of .1mm, the game piece holder in the picture was printed at .2mm because most people seem to print at that layer height. I also used the cheap fillament that came with my printer to print this, as I didn't want to waste my hatchbox fillament. So the quality of the underside of the brim is less than I'd like (could also be the supports, but Simplify3D supports and Hatchbox fillament usually give me better underside results). Printed in one piece, supports are recommended for the entire brim. With finer print settings and quality fillament, this holder will look much cleaner than it already does.
General Print Settings
Layer Height .2mm
Top/Bottom/Perimeter 3 layers
Infill 20%
Time 4h 10 m
Fillament Length 18187.8 mm
Platic Weight 54.68 g
| Date published | 14/05/2018 |