Ana's Biotic Rifle from Overwatch
Ana's Biotic Rifle from Overwatch
3D
Published 2017-12-12T18:19:23+00:00
Ana's rifle from Overwatch.
I've tried to keep supports to a minimum while also getting as much details as I can on each part.
There are slots for 6x3mm magnets on the handle and barrel to make it easier to travel with. There's space in there for 2 stacked ontop of eachother.
I printed the parts at 0.15-0.2mm layer height, 2 perimeters at 8% infill in ABS and acetone-welded the flat surfaces together.
In hindsight, adding some pegs to align them better would have been better. So I'm trying that out on my next print.
I went through about 2/3rds of a spool printing this, so with supports I think it was around 600-700g total. (possibly less since I had to redesign and reprint some fragile parts).
Ana_BayonetSupport x 2
Ana_Barrel2 x 3
Ana_Side1 x 2 - one Mirrored for the other side
Ana_Side2 x 2 - one Mirrored for the other side
Ana_Side3 x 2 - one Mirrored for the other side
Ana_Side4 x 2 - one Mirrored for the other side
| Date published | 12/12/2017 |
| Dimensiones | 115 x 26 x 6cm Assembled. Roughly 70 x 26 x 6cm Disassembled |
| Tecnología | FDM |
| Complejidad | Difícil |
Printed and painted default color. I had some z-wobble issues with my print and fixed it after I printed this so some parts are a bit sketch but its not bad for my first major 3d printer project. I printed this on my Geeetech A10m and a monoprice delta mini