ANYCUBIC Delta/Kossel Plus 220-240mm HeatedBed supports
ANYCUBIC Delta/Kossel Plus 220-240mm HeatedBed supports
3D
Published 2018-06-07T16:27:43+00:00
This model is designed by enry68 (https://bit.ly/2uoUfo0), thank you very much for your great support. For details, please see the description below:
Summary
These are the LEFT and RIGHT supports to be used on a DELTA/Kossel 3d printer. the supports are designed for an HeatedBed of 220mm diameter and a glass of 240mm diameter. The supports can be printed in PLA (ABS is not necessary, tested for a lot of hours @100°C)
These supports uses the original stock screws given with the original supports in the kit of the Anycubic DeltaPlus.
Obviously they can be used also with other Delta printers.
To center the bed, preplace the supports at about 90mm eachother on the same side.
Happy prints.
Printer: Anycubic Delta Plus Linear
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 50%
Notes
Place the supports on the bed on a side so that:
for the LEFT the "8" must be near the bed
-for the RIGHT the "E" must be near the bed
In this way the supports are not required.
| Date published | 07/06/2018 |