Batman HMX Grenade
Batman HMX Grenade
Published 2016-05-10T14:03:24+00:00
Assembly is simple. Print 1 of each file and assemble.
No support necessary for the main body! Drafts have been calculated to allow for this, just print standing up.
The lever should be printed on its side. There will be support material needed for this.
The rest of the parts should also be printed on the widest part down.
Use pictures for reference as necessary.
The lever has built-in interference to the body. This allows spring action similar to actual grenade!
(Based on a pic of a Batman v Superman prop show)
Thank you so much for viewing!
GARROW_3D
The pin is a bit rectangular in shape rather than circular. It was difficult to put into the grenade. Either increase the hole size or adjust the pin. The ring is also quite an issue since it is a smaller part, but I was able to unravel it and put it into the pin. The grenade part is just fine.
Date published | 10/05/2016 |
Tecnología | FDM |
Sin apoyo | YES |