CEL Robox transport Packing clip
6,717
visitas
131
descargas
0 comentarios
Cargando comentarios...
CEL Robox transport Packing clip
3D
Published 2015-03-17T12:53:53+00:00
2
0
Add to Collection
Descripción
Its best to insert this part into your CEL Robox printer when its traviling. It holds the bed down, the head to the right and the X rails up.
To fit it into place, simply press the 'Remove Head' button in Automaker, you dont want to remove the head but it will put the gantry at the right height to fit it. Switch off the power open the door and push the head all the way to the right. The clip goes into the hole in the lower stainless steel part (just visiable behind the bed) and then snaps over the two X rails.
Detalles de impresión
Print at 0.2 mm layer height, with 10% infill. This uses 5 g of filament and takes 23 minutes.
Información técnica
Date published | 17/03/2015 |
¿Cuándo tiempo lleva? | 20 - 25 minutos |
Cantidad de filamento | 5g |
Dimensiones | 52 x 44 x 13 |
Complejidad | Fácil |
Más información
Archivos