Chupacabra, Print in Place Cryptid
$3.00 Chupacabra, Print in Place Cryptid
3D
Published 2023-07-13T20:59:32+00:00
This funky little goat sucker is the legendary Chupacabra. It features a print in place design with fully articulating legs and head! The head is supported by an included built in support.
Keep in mind that the purchase of this model does not include a commercial license. If you want to sell prints of our models please check our out Tribe!
Take a look at our other articulated models!
Recommended Settings
First Layer Adhesion is key! If you are having issues with adhesion, we recommend a few things!
- Use a brim. (4-6mm with a 0.1-0.4 gap)
- Clean you bed, generally with isopropyl alcohol or a good scrub and wash!
Twisty Prints models are generally tested as small as 85%. we do not recommend going below that. If you do it not guarunteed to function properly.
These are our settings :
Layer Height 0.16 to 0.2
Initial Layer Height 0.3
Line Width 0.4
10-15% Gyroid Infill
| Date published | 13/07/2023 |
| Precio | $3.00 |
| Sin apoyo | YES |
100% done in DUDV2 Matte Rainbow