Clay Target Trophy
4,828
visitas
263
descargas
1
colección
0 comentarios
Cargando comentarios...
Clay Target Trophy
3D
Published 2019-08-05T18:44:43+00:00
11
0
Add to Collection
Descripción
This is a trophy I designed for skeet or trap shooting. V3 has a hole in it to fit a US silver dollar. V4 i just planned on getting a disk engraved to fit in the center of the trophy to display what the trophy was for, but you can do what ever with that i suppose.
Supports are 100% needed for V4 as the bottom of the target will print in thin air otherwise. V3 can print without supports, but i'd advise to use them, otherwise the back of the target could get a bit messy.
Licencia
Detalles de impresión
I used 3 perimeters, 20% infill, and at .12mm layer hight.
Printed V4 in Hatchbox gold PLA, and V3 in some coper PLA i had but cant remember the brand.
Información técnica
Date published | 05/08/2019 |
Más información
Archivos