Fidget Spinner "Bearing"
Fidget Spinner "Bearing"
3D
Published 2017-06-16T14:53:42+00:00
This is a "bearing" for fidget spinners. It was modeled to be the same size as the 608 bearings commonly used in fidget spinners. The center hole is 8mm, so you should still be able to use thumb pads. The outer diameter is 22mm and therefore should pop into any spinner you might want to put it in. Finally the "bearing" is 7mm tall.
There are 3 different versions. A loose version (called "bearing") for printers that can't handle tight tolerances, a tighter version ("bearing-tighter") for printers that can handle tight tolerances, and a version with 4 cutouts ("bearing-slots")- based off of the loose version but with cutaways to attempt to reduce friction for a better spin.
There is always room for improvement so comments are welcome.
| Date published | 16/06/2017 |
| ¿Cuándo tiempo lleva? | - 30 minutos |
| Tecnología | FDM |
| Sin apoyo | YES |