Flower Stand
Flower Stand
Published 2017-09-01T15:11:00+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
A cute little flower stand.
This model was created with VECTARY - the free, online 3D modeling tool
Credits:
The image shown here is printed with PLA at 30% scale on a Qiditech 1 dual extruder printer using these settings:
Stand: 10% infill, 2 shells, no supports, no rafts. Took about 1.5 hours
Word "Flowers": 10% infill, 2 shells, no supports, no rafts. The letters were positioned on their sides on the print bed so they could be printed without supports. Took about 1.25 hours.
Stems + Tulip + Rose + Daisy: Printed together as a mixed material print. 10% infill, 2 shells, no supports, no rafts. Took about 15 minutes.
Vase 1: 100% infill, 4 shells, yes supports, yes raft. Took about 10 minutes.
Vase 2: 10% infill, 2 shells, no supports, no rafts. Took about 10 minutes. (In hindsight, it may have come out better with a harder plastic like ABS or with supports.)
Vase 3: 10% infill, 2 shells, no supports, yes raft. Took about 10 minutes.
Date published | 01/09/2017 |