Hairy Lion
Hairy Lion
3D
Published 2017-02-03T11:34:48+00:00
IMPORTANT: It is meant to be printed with 0.2mm layer height. Otherwise it might not print well.
This is a Hairy Lion. As the name says it is lion with hair.
It is a remix of a Lion HD (no supports required) by Geoffro hosted on Thingiverse.
UPDATE: I made 50% smaller version. It should only take about 1-2 hours to print. But you must be much more careful when cutting the hair. This model has much less hair, so if you break or pull out too much hair, there will be visible bald spots.
The hair is connected to sacrificial wall, which is removed afterwards.
(See picture: post_processing.jpg) You can also try hot water to form the hair. Anyway, be careful not to burn yourself.
This was printed with ABS, but it should also work with other materials. If you are having problems, adjust bridging settings in your slicer.
IMPORTANT: It is meant to be printed with 0.2mm layer height. Otherwise it might not print well.
| Date published | 03/02/2017 |
| ¿Cuándo tiempo lleva? | - 270 minutos |
| Dimensiones | 112mm x119mm x104mm |
| Tecnología | FDM |
| Complejidad | Medio |
| Sin apoyo | YES |
Your Big version scaled down to 240mm