Meltink3d Spool Photobooth
Meltink3d Spool Photobooth
3D
Published 2018-04-27T14:26:09+00:00
Simple diy project to convert a empty Meltink3d spool into a simple photobooth for small prints with manual push turntable. No modification of the spool needed. All you need is to print a 7" table (either the whole or the two halves to glue together) and two clips. Clip on the printed clips onto the spool and insert a piece of paper into the clips for a backdrop.
Remixing highly encourage. Clips clip onto spools with a 5mm flange and the table fits into a arbor hole of 52.07mm in diameter.
For more info on Meltink3d filaments visit Meltink3d.com. Use code: twiesner10 to recieve 10% of your next filament order at Meltink3d.com and print this design today!
Print 0.3 mm with 15% fill.
| Date published | 27/04/2018 |
| Sin apoyo | YES |
3.5 hours. 5% infill 0.33 layer height