Momentum Fidget Spinner v2
Momentum Fidget Spinner v2
3D
Published 2017-08-15T15:02:04+00:00
Remix of a previous spinner that required a ceramic bearing. This one doesn't spin as long, but it should go for 30-45 seconds without too much effort. It accelerates more than the previous version since the magnets have more travel without the bearing to get in the way. It requires a few flicks to spin it up since it slows down when the magnets move to the outer position.
Inspired by example prints I saw from whosawhatsis's book, 3D Printed Science Projects*.
Atomic Filament Clearance Translucent Ruby Red PLA and Filamentum Vertigo Gray PLA*
https://www.youtube.com/watch?v=swua50XJmQY
*affiliate links
Printer : Eustathios
Rafts : No
Supports : No
Infill : 100%
Notes : 0.4mm extrusion width recommended
Post printing
Uses [10mm diameter rare earth magnets*](http://amzn.to/2thAkml), which come in a variety of thicknesses - The thinner magnets allow for more configuration options, using more magnets should result in transitioning at higher speeds. [Superlube oil*](http://amzn.to/2sFivjn) or similar - I usually disassemble it after printing and a few minutes of break-in, then add one drop of superlube into each of the pivot points.
How I designed this
Here's the design file if you need to make any adjustments to the tolerances, etc: https://cad.onshape.com/documents/33a28fa59ba204bb3a1306d4/w/5d553ff0b7ec85cfe29740a9/e/43834d9d41c851f0266f0326
| Date published | 15/08/2017 |
| Tecnología | FDM |
| Sin apoyo | YES |
