Montini Reign of Sargon II Wall Set (Lego Compatible)
Montini Reign of Sargon II Wall Set (Lego Compatible)
3D
Published 2020-03-11T09:58:12+00:00 • Remix de Montini building bricks Two Pip Set (Lego Compatible), Montini building bricks Female Plate Set (Lego Compatible), Montini building bricks Pip Strip Set (Lego Compatible), Montini Building Bricks Roof Pieces (Lego Compatible), Montini building bricks One Pip Set (Lego Compatible)
This set of Montini bricks forms a relief showing a figure from Mesopotamia.
Just like the vintage original Montini parts, these are compatible with classic Lego full height bricks.
Montini building bricks were produced from 1961 to 1969 in the Netherlands. They were originally made from soft, pliable polypropylene. The diagonal fins bend slightly around the pips of the other block.
puppenhausmuseum.de/montini-bausteine.html
Please do not mix these with original Montini parts. PLA is much harder than the original bricks, and the layer ridges act like sand paper. You will wear out the original Montini bricks very quickly.
I would love to see your make!
Original art scan by Marchal Geoffrey:
sketchfab.com/3d-models/relief-from-regne-of-sargon-ii-04cd1d1722a545bfa361d9e6db960239
Rafts: No
Supports:Yes
Notes:
These are optimized for a 0.4mm nozzle. They are friction fit parts, so tolerances are important.
I set the Horizontal Shells Top to 7, and Bottom to 10 to allow for the relief to have infill, but the brick to be solid.
The following parts need supports on the relief section. The bricks themselves do not need supports:
0_0_Stele Sargon II.stl
0_1_Stele Sargon II.stl
0_13_Stele Sargon II.stl
1_0_Stele Sargon II.stl
1_1_Stele Sargon II.stl
1_3_Stele Sargon II.stl
1_5_Stele Sargon II.stl
1_9_Stele Sargon II.stl
| Date published | 11/03/2020 |
Thank you left spin