Peter Krige - water cap and flex tap
16,708
visitas
850
descargas
8
colecciones
6 comentarios
Cargando comentarios...
Peter Krige - water cap and flex tap
3D
Published 2014-06-03T18:46:55+00:00
123
6
Add to Collection
Descripción
Design by Peter Kirge -
A hose or plastic tube is attached to the inner nozzle on the Water Cap. This is then inserted into the water container. The cap is screwed on and the inner rubber washer ensures an air tight seal. The water container is half filled with water.
Then a longer piece of hose or plastic tube is attached to the outer nozzle and its other end installed in the flex tap. The flex tap works by creating a kink in the tube which controls or stops the water flow depending on how much the user flexes the handle.
A bicycle pump is connected to the schrader valve and the container pressurised with air.
ADD YOUR COMMENTS BELOW!
Información técnica
Date published | 03/06/2014 |
Más información
Archivos