Pocket Door Hanger / Hinge
3,702
visitas
85
descargas
0 comentarios
Cargando comentarios...
Pocket Door Hanger / Hinge
3D
Published 2015-06-16T11:48:51+00:00
12
0
Add to Collection
Descripción
This is a replacement part for a pocket door. It screws into the top of the door and provides the bearing surface for the door to slide on it's rails. It is designed to be printed in PLA, investment cast, and then threaded. The thread pitch for the original part that was duplicated was 5/16-32, so was too fine to print or cast successfully.
In the picture, the original die cast piece is on the left and three replacement parts that were printed in PLA and then cast in brass are shown on the right.
Detalles de impresión
Print at 0.2 mm layer height, with 10% infill. This uses 1 g of filament and takes 5 minutes.
Información técnica
Date published | 16/06/2015 |
¿Cuándo tiempo lleva? | 5 - 10 minutos |
Cantidad de filamento | 1 g |
Dimensiones | 13 x 40 x 13 |
Complejidad | Muy fácil |
Más información
Archivos