Pokeball Switch Cartridge Case
Pokeball Switch Cartridge Case
3D
Published 2017-10-12T09:37:00+00:00
Please watch my video for assembly
BTC: 32tbiUptu5Lo1a44jQvhRjX9f5r2KNaFwr
ETH: 0x84254e3A8c2644373206573927825F344C108058
Remixed from https://www.thingiverse.com/thing:645246
Pokeball stand from https://www.thingiverse.com/thing:411193
The spring release I used is actually from a cheap Pokeball I had around at home that you can buy online for a few bucks. Some 1.75mm filament will also work as a hinge that can be opened manually. You may need to drill or melt a slightly bigger if you want to do that.
The holes where the wire go in for the button may not print properly because of how fine they are, so you may need to drill or heat up a pin to puncture the holes instead.
I printed mine with auto supports. If you do the same, make sure to remove any little pieces where the button clicks into position on the upper and lower inside parts as they can get easily missed. If not the button might be too sensitive.
| Date published | 12/10/2017 |
| Tecnología | FDM |
| Complejidad | Medio |
Thanks for the model :)