Rear Vent Duct Adapters for Anycubic Photon
18,692
visitas
893
descargas
21
colecciones
2 comentarios
Cargando comentarios...
Rear Vent Duct Adapters for Anycubic Photon
3D
Published 2018-05-04T10:12:46+00:00
138
2
Add to Collection
Descripción
These are two version of my rear vent duct adapters for the Anycubic Photon:
- A 4" version for connecting to standard ventilation tubing
- A 2.5" version for connecting to vacuum hoses and smaller tubing
You can find installation instructions and some links to example ventilation hardware at the original Thingiverse page.
If you choose to remix or share this, you are free to do so with attribution. However, you must release it under the same CC-BY-SA license.
Detalles de impresión
Print with the rectangular vent side on the print bed. 0.3mm layer hights work fine, but you can go bigger or smaller depending on your desired finish quality.
Información técnica
Date published | 04/05/2018 |
Sin apoyo | YES |
Más información
Archivos