self-centering hole jig
3,087
visitas
178
descargas
6
colecciones
0 comentarios
Cargando comentarios...
self-centering hole jig
3D
Published 2019-10-20T17:40:12+00:00
33
0
Add to Collection
Descripción
This jig is used to drill a hole in the center of an edge. used when you want to connect two pieces of wood side by side with dowels.
Instructions :
1. print the jig body.
2. print the bearing 2 times.
3. print the bearing cap 2 times.
4 insert the bearing into the body.
5. carefully lock the bearing with the cap. it shuld make a very tight fit with no glue required.
The jig can accept up to 60mm thick material. the hole is 4mm in diameter used to drill the center pilot hole and then you can make the hole bigger with a bigger drill bit.
Licencia
Información técnica
Date published | 20/10/2019 |
Sin apoyo | YES |
Más información
Archivos